![]() Ĭonnecting the antennas and power cord, etc. There are different balancers with different schemes but this is how this one is done.Supplementary information | Advanced Setup | Others The harness is an experimental one that Evan made up for me. Unfortunately its confusing because Im charging two 3S pack in series.like one 6S pack. When you have the balance program called up for LiPos and want to charge that way you have to connect to both the balance and charge plugs on the battery pack. I own a BC-6 and charge everything I have on it.NiMh, LiPo, garden tractor battery. I might recommend an adapter if I can find out what connector your battery has. You should look into the battery power connector to see what you need to make the connection. So you might have to buy (or solder) an adapter that will make the connection between both outputs. The charger wont even detect your battery by only the balance plug, and thus displays the connection break message. You have to get the power output from your battery into the output of the BC6 (which are the female banana plugs on the right). Ive taken a closer look at the connector of the cord and cant see that it makes a differnce regard the black pair being installed as pins 1-2 or pins 7-8. Regards polarity in general, the umbilicle cord between the BC6 and the ALIGN card consists of 8 wires, 6 red and 2 black. The 2 boards each had there own cable to connect to the charger, the polarity is opposite on each cable and if I used the wrong one I would get connection break error. Mine came with 2 boards, one for Thunder Power and one for whatever most other batteries use, including E-Sky. I had to rewire the balance connector.It was a 5 pin connector on a 3S lipo with one space skipped, why the battery was wired like that I dont know but I eliminated the space and it worked.Īlso, if any cell in your battery is over charged (above 4.21v) or over discharged (belowģv, I think) the charger will give you an error and not work. Having tried and re-tried the connections over and over to no success, Ive come to the conclusion that this sport is a taxing sport. With the battery firmly connected to the proper socket (4 posts and also polarized), i start the charge by holding the STARTENTER button down for 3 seconds.Ī BATTERY CHECK message is displayed and within seconds the unit is beeping with a CONNECTION BREAK message.ĬONNECTION BREAK seems to imply an interruption between the battery and the unit. In addition, the receptors on both the mother unit and the daughter board are also polarized. Regardless, the connection appear quite straightforward with the cable having a polarized ends. Make sure you select the right cell count and charge current.Īs usual, there is no documentation regards making this connection so to some extent Im on my own (heres where you get involved). Rc Power Bc6 User Manual By genonarco1980 Follow | Public ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |